Place bobbin winder 3 in the belt cover, and position it so that it does not contact the machine arm or the belt cover before fixing it with wooden screws. 把绕线装置3放到皮带护罩里,调整到不接触机架和皮带护罩的位置,然后用木螺丝进行固定。
The rules bar foreign agencies that sell financial news and information to non-media customers in China from direct contact with their clients, requiring them to work through an arm of Xinhua instead. 上述规定禁止向中国非媒体客户销售财经新闻及信息的外国通讯社与其客户直接接触,要求它们必须通过新华社下属机构接触客户。
A contact in the distributor; as the rotor turns its projecting arm contacts distributor points and current flows to the spark plugs. 分配器中的节点;转动体把联系着分配器和电流的突出的胳膊为活力塞。
Poor contact at the junction of cable magneto breaker arm point 电缆接点处接触不良磁电机断电器臂接触点
This helps to prepare you for any contact your arm may meet as you attack an opponent. 这样有助于你在进攻对手时能够粘住对方。
Folded cantilever contact horizontal arm hanging type centrifugal casting machine 折叠悬臂式触点簧片悬臂卧式离心铸造机
The linear inequality constraint of contact force is obtained by using dynamic equation of robotic arm and joint generalized driving force constraint. 通过臂动力学方程和关节广义驱动力约束,给出多臂协调抓持力不等式约束;
Force analysis for object grasped by multiple robotic arms is presented in this paper based on the two contact types of hard point and soft finger between robotic arm and object. 基于机械臂与工件的硬点和软指两种接触方式,对工件的受力进行分析,建立臂与工件保持接触应满足的约束条件;
Because of the influence of the contact effect, the work efficiency of thermoelectric generator will fall with length decreasing of couple arm. The more remarkable of contact effect, the more quickly of the work efficiency will fall. 由于接触效应的影响,温差发电器的工作效率将随温差电偶臂长度的减小而降低,而且接触效应影响越显著,工作效率降低的就越迅速。
Ilizarov distraction in the minimally invasive technique under moderate stress stretch, increasing the fiber and the bone contact area, increasing the role of Achilles tendon moment arm, is a remodeling, is a compensatory response, is an adaptation of change. 3. 在Ilizarov微创牵张技术适度牵拉应力下,增大了纤维与骨的接触面积,加大了跟腱的作用力臂,是一种塑形改建,是代偿性反应,是一种适应性改变。
Support arm module of hydraulic output device of drive unit adopt 2-DOF seven-link linkage, the contact arm of the mechanism can touch undulant open hole wall tight and provide enough confined normal force. 驱动单元液压出力装置的支撑臂组件采用具有2个自由度的7杆机构,该机构的接地臂可与起伏变化的裸眼井壁紧密接触,提供足够大的封闭正压力。